Ignition Sensor Pickup Coil for Polaris Switchback 800 2004-2005 2010
Ignition Sensor Pickup Coil for Polaris Switchback 800 2004-2005 2010
Couldn't load pickup availability
Ignition Sensor/Pickup Coil for Polaris Switchback 800
This new ignition sensor and pickup coil supplies the trigger pulse that tells the ignition when to fire on Polaris Switchback 800 models, replacing the original sensor directly.
Overview
This ignition sensor and pickup coil is a new replacement part for the ignition system on Polaris Switchback 800 snowmobiles. It picks up the flywheel trigger and sends the timing signal to the CDI so the engine fires on schedule. Riders servicing a no-spark or erratic-spark issue on 2004, 2005, or 2010 Polaris Switchback 800 machines can use this pickup coil as a direct-fit replacement.
Built For Performance
- New ignition sensor and pickup coil assembly, not a used take-off
- Coil winding and molded body matched to the factory trigger signal
- Direct replacement for the original pickup coil on Polaris Switchback 800 engines
- Factory-style connector and lead wire for plug-in installation
- Rated for the heat, vibration, and cold of two-stroke snowmobile use
Fits These Machines
- for Polaris Switchback 800, 2004
- for Polaris Switchback 800, 2005
- for Polaris Switchback 800, 2010
On-The-Job Use
- Restoring spark on a Polaris Switchback 800 that cranks without firing
- Replacing a failed pickup coil during ignition diagnostics
- Shop or trailside repair on 2004, 2005, and 2010 Polaris Switchback 800 sleds
- Preventive swap when the original sensor shows heat damage or worn insulation
Specs At A Glance
| Type | Ignition sensor and pickup coil |
| Condition | New |
| Application | for Polaris Switchback 800, 2004-2005, 2010 |
Good To Know
Q: How can I tell if the pickup coil has failed? A: A bad pickup coil usually shows up as no spark or an intermittent spark, so measure resistance at the sensor connector against your service manual spec before ordering. Q: Is the connector and wiring included? A: Yes, this sensor and pickup coil come as a complete assembly with the lead and plug, so it connects to the factory harness without splicing.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
