Ignition Sensor Pickup Coil for Yamaha Rage 973 cc 2005-2007 GT
Ignition Sensor Pickup Coil for Yamaha Rage 973 cc 2005-2007 GT
Couldn't load pickup availability
Ignition Sensor/Pickup Coil for Yamaha Rage
This new ignition sensor and pickup coil provides the trigger signal your engine needs to fire the ignition at the correct moment, direct replacement for Yamaha Rage 973 cc models.
Overview
This ignition sensor and pickup coil is a new replacement component that delivers the timing signal from the flywheel to the ignition system on Yamaha Rage 973 cc snowmobiles. The pickup coil reads the trigger on the flywheel and sends that pulse to the CDI, which fires the spark at the right instant. It is a direct-fit replacement for riders servicing a no-spark or weak-spark condition on 2005 through 2007 Yamaha Rage machines.
Built For Performance
- New ignition sensor and pickup coil assembly, not a used or refurbished part
- Wound coil and molded housing designed to match the factory trigger signal
- Direct replacement for the original pickup coil on Yamaha Rage 973 cc engines
- Sealed connector and lead wire ready for plug-in installation
- Built to withstand the heat, vibration, and cold of snowmobile engine operation
- OEM cross-reference GT
Fits These Machines
- for Yamaha Rage 973 cc, 2005
- for Yamaha Rage 973 cc, 2006
- for Yamaha Rage 973 cc, 2007
On-The-Job Use
- Restoring spark on a Yamaha Rage that cranks but will not fire
- Replacing a failed pickup coil during routine ignition troubleshooting
- Trailside or shop repair on 2005 to 2007 Yamaha Rage snowmobiles
- Preventive replacement when the original sensor shows heat damage or cracked insulation
Specs At A Glance
| Part Number(s) | GT |
| Type | Ignition sensor and pickup coil |
| Condition | New |
| Application | for Yamaha Rage 973 cc, 2005-2007 |
Good To Know
Q: How do I know the pickup coil is the problem? A: A failed pickup coil typically causes a no-spark or intermittent-spark condition, so check resistance at the sensor connector against your service manual spec before replacing. Q: Does this come with the connector and wiring? A: The sensor and pickup coil are supplied as a complete assembly with the lead and plug, so it connects to the factory harness without splicing.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
