Ignition Sensor Pickup Source Coil for Arctic Cat M5 500 2005-2006
Ignition Sensor Pickup Source Coil for Arctic Cat M5 500 2005-2006
Couldn't load pickup availability
Ignition Sensor (Pickup/Source Coil) for Arctic Cat M5
This ignition sensor (pickup/source coil) for Arctic Cat M5 delivers the trigger signal your snowmobile engine needs to fire at the right moment. It replaces the original pickup coil on 2005-2006 Arctic Cat M5 models, restoring reliable spark and clean throttle response.
Overview
This ignition sensor (pickup/source coil) for Arctic Cat M5 is the trigger component that signals your CDI to fire the ignition at the correct time. Built as a direct-fit replacement for the original pickup coil, this ignition sensor restores consistent spark and dependable starting on 2005-2006 Arctic Cat M5 snowmobiles. It suits riders and mechanics replacing a failed or weak source coil on a machine that has become hard to start or is misfiring.
Built For Performance
- Direct-fit replacement for the factory pickup/source coil on Arctic Cat M5 models
- Delivers a clean trigger signal to the CDI for consistent ignition timing
- Restores reliable cold starts and steady spark at higher RPM
- Plug-and-play wiring connection matched to the original harness
- Construction suited to the vibration and temperature swings of snowmobile use
Fits These Machines
- for Arctic Cat M5 2005
- for Arctic Cat M5 2006
On-The-Job Use
- Replacing a failed pickup coil that has caused a no-spark condition
- Fixing misfires and rough running traced to a weak source coil signal
- Routine ignition service on 2005-2006 Arctic Cat M5 snowmobiles
- Trailside or shop repairs where dependable spark is essential
Specs At A Glance
| Part Type | Ignition Sensor (Pickup/Source Coil) |
| Position | Stator pickup / source coil |
| Fitment Years | 2005-2006 |
| Machine | for Arctic Cat M5 |
Good To Know
Q: What are the signs of a bad pickup coil? A: Common signs include no spark, hard starting, misfiring, and cutting out at higher RPM. A weak source coil often shows up as an intermittent fault that worsens as the engine warms.
Q: Does this replace the factory sensor directly? A: Yes, this ignition sensor is designed as a direct-fit replacement for the original pickup/source coil on the listed models. Confirm your machine's year and model before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
