Ignition Sensor Pickup Source Coil for Arctic Cat M7 700 2005-2006
Ignition Sensor Pickup Source Coil for Arctic Cat M7 700 2005-2006
Couldn't load pickup availability
Ignition Sensor (Pickup/Source Coil) for Arctic Cat M7
This ignition sensor (pickup/source coil) for Arctic Cat M7 provides the critical timing signal your snowmobile's ignition system needs to fire the spark plugs at the correct moment.
Overview
This ignition sensor (pickup/source coil) for Arctic Cat M7 delivers the electrical pulse that triggers the ignition system on 2005-2006 M7 700 snowmobiles. The ignition sensor for Arctic Cat M7 is a direct-fit replacement for a failed or weak pickup coil that causes hard starting, misfiring, or loss of spark. Whether you are doing a full ignition overhaul or replacing a coil that has finally given out, this ignition sensor for Arctic Cat M7 gets you back on the snow.
Built For Performance
- Direct-fit replacement for the original pickup/source coil on 2005-2006 Arctic Cat M7 700 models
- Provides the trigger signal the CDI needs to time spark correctly
- Designed to match OEM electrical resistance for reliable signal output
- Sealed construction resists moisture and vibration in cold, wet conditions
- Plug-in style connector for simple installation
- Works with the factory ignition wiring harness
Fits These Machines
- for Arctic Cat M7 700 (2005)
- for Arctic Cat M7 700 (2006)
On-The-Job Use
- Replacing a failed pickup coil that has caused a no-spark condition
- Fixing hard starting or erratic timing on the trail
- Restoring reliable ignition during routine engine maintenance
- Getting a mountain sled back in service after an electrical fault
- Keeping a spare part on hand for high-mileage sleds
Specs At A Glance
| Part Number(s) | 700 |
| Type | Ignition Sensor (Pickup/Source Coil) |
| Fitment | for Arctic Cat M7 2005-2006 |
| Function | Ignition timing trigger |
Good To Know
Q: How do I know if my pickup coil is bad? A: A failed pickup coil often causes a no-spark condition, hard starting, or intermittent misfiring that worsens as the engine warms up. Testing resistance with a multimeter and comparing it to spec confirms whether replacement is needed.
Q: Is this an original Arctic Cat part? A: This is an aftermarket ignition sensor designed to fit Arctic Cat M7 models and match the function of the original pickup coil. It is not an Arctic Cat branded part.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
