Ignition Sensor Pickup Source Coil for Arctic Cat Powder Extreme 600 1997-1998
Ignition Sensor Pickup Source Coil for Arctic Cat Powder Extreme 600 1997-1998
Couldn't load pickup availability
Ignition Sensor (Pickup/Source Coil) for Arctic Cat
This ignition sensor for Arctic Cat serves as a pickup and source coil that delivers the trigger signal needed to fire the ignition at the correct moment. The unit cross-references Arctic Cat OEM part numbers 3005-808 and 3005-882 in the listed application.
Overview
This ignition sensor (pickup/source coil) for Arctic Cat is a direct-fit replacement for a failed trigger coil on the listed 600 snowmobile engines. The ignition sensor restores consistent spark timing, which helps the engine start cleanly and run smoothly through the entire RPM range. It is intended for riders and mechanics servicing 1997 to 1998 Arctic Cat Powder Extreme 600 machines.
Built For Performance
- Coil and pickup combined into one plug-in assembly
- Produces a stable trigger signal for the CDI box
- Direct-fit mounting pattern for the listed Arctic Cat 600 engines
- Sealed construction resists moisture and vibration
- Restores reliable cold starts and throttle response
Fits These Machines
- for Arctic Cat Powder Extreme 600 (1997-1998)
On-The-Job Use
- Replacing a failed pickup coil on a 1997-1998 Powder Extreme 600
- Diagnosing no-spark or intermittent-spark conditions
- Top-end rebuilds where the ignition sensor is disturbed
- Pre-season tune-ups on older Arctic Cat 600 snowmobiles
Specs At A Glance
| Part Number(s) | 3005-808, 3005-882 |
| Type | Ignition sensor (pickup/source coil) |
| Engine Fitment | 600cc, 1997-1998 |
Good To Know
Q: How do I know the pickup/source coil is the problem? A: A no-spark or weak-spark condition with a known-good CDI often points to the trigger coil, so test resistance before ordering. A failed sensor can also cause erratic timing and hard starting.
Q: Does this sensor need any special setup? A: It mounts in the stock location with the original air gap, so no timing adjustment is normally required. Recheck the gap and wire routing after installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
