Ignition Sensor Pickup Source Coil for Arctic Cat Powder Special 500 600 700
Ignition Sensor Pickup Source Coil for Arctic Cat Powder Special 500 600 700
Couldn't load pickup availability
Ignition Sensor (Pickup/Source Coil) for Arctic Cat Powder Special 500/600/700
This ignition sensor (pickup/source coil) for Arctic Cat Powder Special 500, 600, and 700 delivers the trigger signal your ignition needs for consistent spark on the mountain.
Overview
This ignition sensor for Arctic Cat Powder Special is the pickup and source coil that reads the flywheel and feeds the CDI so timing stays correct under load. If your Powder Special 500, 600, or 700 has gone no-spark or starts cutting out, replacing the ignition sensor for Arctic Cat Powder Special is often the fix. It bolts in place of the original pickup with a factory-matching connector.
Built For Performance
- Direct replacement for the stock pickup and source coil
- Wound to original resistance values for a strong trigger signal
- Sealed coil body stands up to moisture, powder, and engine heat
- Factory-style plug-in connector for a straightforward install
- Designed to maintain timing stability through the rpm range
- Built for reliable starts in deep-cold mountain conditions
Fits These Machines
- for Arctic Cat Powder Special 500
- for Arctic Cat Powder Special 600
- for Arctic Cat Powder Special 700
On-The-Job Use
- Replacing a failed pickup coil behind a no-spark condition
- Fixing an engine that misfires or quits once it gets hot
- Pre-season ignition servicing on a mountain sled
- Getting a high-country rebuild back on the snow
Specs At A Glance
| Part Type | Ignition Sensor (Pickup/Source Coil) |
| Position | Stator / Flywheel Pickup |
| Compatible Models | for Arctic Cat Powder Special 500 / 600 / 700 |
Good To Know
Q: How do I test a pickup or source coil? A: Measure resistance across the coil leads with a multimeter and compare to the factory spec for your engine. A reading that is open or far out of range points to a failed pickup coil.
Q: Is this an original Arctic Cat part? A: This is an aftermarket ignition sensor built to fit Arctic Cat Powder Special applications. It is not an original Arctic Cat component.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
