Ignition Sensor Pickup Source Coil for Arctic Cat ZL 800 EFI 2001-2003
Ignition Sensor Pickup Source Coil for Arctic Cat ZL 800 EFI 2001-2003
Couldn't load pickup availability
Ignition Sensor (Pickup/Source Coil) for Arctic Cat ZL 800 EFI
This ignition sensor (pickup/source coil) fits Arctic Cat ZL 800 EFI models from 2001 through 2003 and provides the trigger signal the ignition system uses to time spark delivery.
Overview
This ignition sensor, also called a pickup or source coil, fits Arctic Cat ZL 800 EFI machines built between 2001 and 2003. The ignition sensor sends the timing pulse the CDI relies on to fire the spark at the right instant, which keeps the ZL 800 EFI starting easily and pulling cleanly across the powerband. It suits riders and mechanics replacing a worn or failed pickup coil on this EFI snowmobile.
Built For Performance
- Direct replacement for the stock pickup/source coil on 2001-2003 Arctic Cat ZL 800 EFI models
- Delivers a steady trigger signal for consistent ignition timing
- Coil construction built to handle the vibration and heat of a snowmobile engine bay
- Factory-style connector and mounting points for a clean install
- Brings back reliable spark and smooth running when the original sensor quits
Fits These Machines
- for Arctic Cat ZL 800 EFI, 2001
- for Arctic Cat ZL 800 EFI, 2002
- for Arctic Cat ZL 800 EFI, 2003
On-The-Job Use
- Trail riding and lake running on the ZL 800 EFI
- Replacing a failed pickup coil during ignition troubleshooting
- Restoring spark on machines with no-start or intermittent spark issues
- Shop and DIY repair work on 2001-2003 ZL 800 EFI models
Specs At A Glance
| Part Type | Ignition Sensor (Pickup/Source Coil) |
| Machine | for Arctic Cat ZL 800 EFI |
| Model Years | 2001-2003 |
Good To Know
Q: What symptoms point to a bad pickup coil? A: No spark, weak or intermittent spark, hard starting, and misfiring once warm are typical signs. Checking resistance against the service specification helps confirm the sensor has failed before you replace it.
Q: Is any timing adjustment required after fitting this sensor? A: No, it mounts in the factory position, so the air gap and timing stay as originally designed. Install it the same way the old sensor was removed and verify spark before buttoning everything back up.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
