Ignition Switch 96008-SGT for Genie QS-12R QS-12W QS-15R QS-15W QS-20R QS-20W

Ignition Switch for Genie

This ignition switch with OEM cross-reference 96008-SGT provides reliable power control for Genie aerial work platforms, designed to start and stop the engine on Genie QS series scissor lifts.

Overview

This ignition switch is a direct replacement for Genie QS-12R QS-12W QS-15R QS-15W QS-20R QS-20W scissor lifts, ensuring your machine starts reliably every time. The 96008-SGT switch is built to withstand tough job site conditions and delivers consistent performance in daily operation.

Built For Performance

• Rugged construction resists vibration and shock on the job site
• Weather-resistant contacts prevent corrosion in outdoor use
• Easy plug-and-play installation matches original switch wiring
• Precision key mechanism provides positive on-off feel
• Rated for heavy-duty start cycles common in aerial lifts

Fits These Machines

• for Genie QS-12R
• for Genie QS-12W
• for Genie QS-15R
• for Genie QS-15W
• for Genie QS-20R
• for Genie QS-20W

On-The-Job Use

• Construction site material handling with scissor lifts
• Warehouse stock picking and inventory access
• Facility maintenance and overhead lighting repairs
• Film and event rigging for elevated stage work

Specs At A Glance

Good To Know

Q: What should I check if my new ignition switch does not work? A: Verify that the wiring harness matches the original switch configuration and that the switch is properly seated in the dash panel. Test with a multimeter to confirm continuity in the run position.

Q: Can this switch be used on older Genie models not listed? A: The 96008-SGT switch is designed for the QS series; consult your machine's manual or serial number to ensure compatibility before installing.

Slight variation in finish or dimensions may occur between production runs, and confirm compatibility before ordering.