Ignition Switch Acuator Pin FOR Jeep Dodge Chrysler Plymouth 4664099 4690492ab

Ignition Switch Actuator Pin for Jeep, Dodge, Chrysler, and Plymouth

This ignition switch actuator pin connects the key cylinder to the ignition switch module to initiate engine startup. This ignition switch actuator pin transfers mechanical rotation into the electrical signal necessary for vehicle ignition. Using the OEM cross-references 4664099 and 4690492ab, this actuator ensures reliable startup for various Chrysler-group vehicles.

Overview

The ignition switch actuator pin is a common wear component in older ignition systems. This ignition switch actuator pin resolves issues where the key rotates but the vehicle fails to crank. It is intended for owners or mechanics performing steering column repairs.

Built For Performance

• Durable cast metal construction for longevity
• Precisely machined tip for engagement
• Matches factory mechanical tolerances
• Resistant to fatigue during frequent operation
• Direct replacement for OEM actuator designs

Specs At A Glance

Good To Know

Q: Is this part difficult to install? A: Installation requires disassembly of the steering column trim and removal of the ignition lock cylinder housing.

Q: Does this replace a broken pin? A: Yes, if your key feels like it is spinning without resistance, this pin is likely the source of the failure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.