Inner Clutch Cover Gasket for Honda TRX200 1984 TRX 200

Inner Clutch Cover Gasket for Honda

This inner clutch cover gasket seals the inner clutch cover to the engine case on the Honda TRX200, keeping oil contained and the clutch assembly shielded from dirt and water.

Overview

This inner clutch cover gasket is a replacement sealing component for the Honda TRX200 from 1984. It fits between the inner clutch cover and the engine case to prevent oil seepage and protect the clutch area from outside contaminants. It is aimed at owners performing clutch service, gasket replacement, or engine reseal work on a Honda TRX200.

Built For Performance

• Cut to match the inner clutch cover mounting surface on the Honda TRX200
• Seals against engine oil and heat within the clutch compartment
• Compressible material conforms to the cover face for a tight joint
• Direct replacement for the original gasket on the 1984 model
• Sold as a single gasket for one inner cover installation

Fits These Machines

• for Honda TRX200 1984

On-The-Job Use

• Inner clutch cover removal and reseal during clutch service
• Routine maintenance on utility ATVs where the cover has begun to weep oil
• Rebuilds after inspecting the clutch assembly and inner cover

Specs At A Glance

Good To Know

Q: Does this gasket require any sealant during installation? A: It typically installs dry on a clean, flat surface, though a light gasket dressing can help hold it in position. Check the cover and case faces for damage before tightening the bolts.

Q: Should the inner clutch cover gasket be reused after the cover comes off? A: It is best replaced every time the inner cover is removed, as compressed gaskets rarely reseal properly. A new gasket prevents oil leaks and keeps contaminants out of the clutch area.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.