Inner Outer Tie Rods Ends Upgrade Kit for Arctic Cat XC 450 2011-2015
Inner Outer Tie Rods Ends Upgrade Kit for Arctic Cat XC 450 2011-2015
Couldn't load pickup availability
Tie Rods & Ends Kit for Arctic Cat XC 450
This inner and outer tie rod and end kit replaces worn steering linkage on the Arctic Cat XC 450, restoring precise steering response for riders who depend on their machine.
Overview
This tie rod and end kit is built to refresh the front steering linkage on the Arctic Cat XC 450, giving the machine tight, predictable steering again. Each tie rod and end in the set is designed as a direct-fit replacement for the stock components, so the installation is straightforward. It suits riders doing their own maintenance who want a complete steering rebuild in one purchase.
Built For Performance
- Complete set of inner and outer tie rods with ends for both sides of the front steering
- Constructed from durable steel for reliable strength under trail and utility use
- Threaded ends allow toe alignment adjustment after installation
- Designed as a direct replacement for the original linkage layout
- Corrosion-resistant finish helps withstand mud, water, and weather exposure
- Sold as a kit so both sides can be serviced at the same time
Fits These Machines
- for Arctic Cat XC 450 (2011-2015)
On-The-Job Use
- Trail riding where steering precision matters on tight, technical terrain
- Utility work on the farm or property that puts constant load on the front end
- Replacing bent or worn tie rods after impact with rocks or stumps
- Routine front-end maintenance when play develops in the steering
Specs At A Glance
| Part Type | Inner and outer tie rods with ends |
| Position | Front steering linkage |
| Compatible Model | for Arctic Cat XC 450 |
| Model Years | 2011-2015 |
| Kit Contents | Inner and outer tie rods and ends |
Good To Know
Q: Do I need an alignment after installing this kit? A: Yes, toe settings should be checked and adjusted after installing new tie rods and ends, since the new components will not match the old worn geometry. A basic toe measurement with the wheels on the ground is usually sufficient.
Q: Can I install this kit with basic hand tools? A: Most riders can complete the job with standard wrenches, a torque wrench, and a way to separate the old tie rod ends from the steering knuckle. Penetrating oil on the old fasteners helps on machines that see a lot of mud.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
