Inside Door Handle For 01-07 Ford Escape/Mercury/Mazda-Front/Rear Left Driver
Inside Door Handle For 01-07 Ford Escape/Mercury/Mazda-Front/Rear Left Driver
Couldn't load pickup availability
Inside Door Handle for Ford Escape / Mercury / Mazda
This inside door handle is the interior release lever that opens the front or rear left driver door from inside the cabin, and it replaces a broken or stiff original lever on the listed models.
Overview
This inside door handle gives the front or rear left driver door a firm, reliable pull on the listed Ford Escape, Mercury, and Mazda vehicles. It restores an interior door latch that has cracked, gone loose, or stopped releasing, so passengers and drivers can exit without fighting the handle. A direct-fit inside door handle for Ford Escape, Mercury, and Mazda owners who want a straightforward replacement part.
Built For Performance
- Direct replacement for the factory interior door release lever
- Sturdy construction to handle daily pull force
- Fits the left driver side in both front and rear positions
- Includes the lever and mounting provisions shown for a straightforward swap
- Designed to match the original handle geometry for proper cable engagement
Fits These Machines
- for Ford Escape 2001 to 2007
- for Mercury vehicles listed in this fitment range
- for Mazda vehicles listed in this fitment range
On-The-Job Use
- Replacing a cracked or loose interior door handle on the driver side
- Restoring smooth interior door release after a broken lever
- Routine repair on high-mileage Ford Escape, Mercury, and Mazda models
- Front or rear left door service during interior trim work
Specs At A Glance
| Position | Front or rear left (driver side) |
| Type | Interior door handle |
| Application | for Ford Escape, Mercury, and Mazda models in the listed range |
Good To Know
Q: Does this handle work on both front and rear doors? A: Yes, this part is listed for front or rear left driver door positions. Confirm the door location and trim level before ordering.
Q: Will I need to reuse any original parts? A: In most cases the original door panel clip and cable connection are reused during install. Check your model's specific procedure first.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
