Intake Exhaust Valve Spring Retainer for Can-Am Quest 500 2002-2003

Intake/Exhaust Valve Spring Retainer for Can-Am

This intake/exhaust valve spring retainer for Can-Am Quest 500 keeps valve springs seated and aligned so the valvetrain holds its timing and compression.

Overview

This valve spring retainer for Can-Am is a valvetrain component that locks the valve spring in place on the valve stem, holding spring tension steady as the camshaft opens and closes the valves. Built to suit the Quest 500 from 2002 to 2003, it serves riders and mechanics rebuilding a top end or replacing worn retainers after a valve job.

Built For Performance

• Holds the valve spring square to the valve stem for consistent valvetrain geometry
• Fits both intake and exhaust valve positions on the Quest 500
• Machined to seat cleanly against the valve spring retainer groove
• Withstands repeated spring compression cycles under engine heat
• Direct replacement for a worn, cracked, or fatigued retainer

Fits These Machines

• for Can-Am Quest 500 2002
• for Can-Am Quest 500 2003

On-The-Job Use

• Top end rebuilds and valve jobs
• Valve spring and seal replacement
• Restoring compression on a tired engine
• Routine inspection when the cylinder head is off

Specs At A Glance

Good To Know

Q: How many retainers should I order for a full top end? A: Order one retainer per valve position you are servicing, and replace them as a set when the head is apart for even wear.

Q: Does this retainer work for both intake and exhaust valves? A: This retainer is listed for both intake and exhaust valve spring positions on the Can-Am Quest 500.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.