Intake/Exhaust Valve Spring Retainer for Sea-Doo GTI SE DT 1503 2007

Intake/Exhaust Valve Spring Retainer for Sea-Doo

This intake and exhaust valve spring retainer for Sea-Doo keeps valve springs properly seated and aligned inside the 1503 engine used in the 2007 GTI SE DT.

Overview

This valve spring retainer for Sea-Doo is a small but critical valvetrain component that holds the valve spring in position on the valve stem. Built for the 1503 engine found in the 2007 GTI SE DT, it helps maintain consistent spring tension so the intake and exhaust valves open and close as designed. A smart pick for riders rebuilding a cylinder head or refreshing top-end valvetrain parts on a Sea-Doo 1503.

Built For Performance

• Holds intake and exhaust valve springs securely on the valve stem
• Fits the 1503 engine platform listed for the 2007 GTI SE DT
• Constructed to withstand repeated high-rpm valvetrain cycling
• Helps maintain correct spring seat pressure for consistent valve timing
• Sold as a replacement valvetrain component for rebuild and service work

Fits These Machines

• for Sea-Doo GTI SE DT 1503, 2007

Specs At A Glance

Good To Know

Q: How many retainers do I need for a full valve job? A: A retainer is typically required for each valve, so confirm the valve count on your 1503 engine before ordering. Ordering enough for both intake and exhaust valves avoids a second shipment mid-rebuild.

Q: Should retainers be replaced with the valve springs? A: Replacing retainers alongside springs and seals is common practice during a top-end rebuild. It helps restore consistent spring seating and reduces the risk of reused parts wearing out early.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.