Intake/Exhaust Valve Spring Retainer for Sea-Doo GTI STD 1503 2006 2019

Intake/Exhaust Valve Spring Retainer for Sea-Doo

This intake/exhaust valve spring retainer keeps valve springs positively located in the Sea-Doo 1503 engine cylinder head so the valvetrain stays stable at high rpm.

Overview

This valve spring retainer is a valvetrain component made to hold valve springs in place on the Sea-Doo 1503 engine. It keeps spring tension centered on the valve stem so the intake and exhaust valves open and close cleanly. This valve spring retainer suits riders maintaining or rebuilding a Sea-Doo GTI STD 1503.

Built For Performance

• Holds the valve spring squarely on the valve stem
• Maintains consistent spring tension through the rpm range
• Fits both intake and exhaust valve positions
• Built to handle the heat and load of the 1503 engine
• Direct replacement for the original retainer

Fits These Machines

• for Sea-Doo GTI STD 1503

On-The-Job Use

• Valve service and top-end rebuilds
• Restoring correct valvetrain geometry
• Replacing worn or damaged retainers
• Keeping valve springs aligned under load

Specs At A Glance

Good To Know

Q: Do I need to replace retainers in sets? A: Retainers are commonly replaced as a set during a valve job to keep spring loads even. Inspect each one for wear before reuse.

Q: Will this fit both intake and exhaust valves? A: This retainer is listed for both intake and exhaust valve positions on the 1503 engine. Confirm against your machine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.