Intake Exhaust Valve Spring Retainer for Sea-Doo GTS 1503 2015 PWC

Intake/Exhaust Valve Spring Retainer for Sea-Doo

This intake/exhaust valve spring retainer keeps valve springs properly seated in the 1503 engine used on Sea-Doo GTS watercraft from 2015, helping maintain correct valve timing and compression.

Overview

This valve spring retainer is a direct-fit engine component for the Sea-Doo GTS and its 1503 powerplant. It holds the valve spring in position on the valve stem so the valvetrain stays stable at high RPM. It suits riders and mechanics servicing or rebuilding a 1503 top end.

Built For Performance

• Retains valve spring alignment on the 1503 valve stem
• Withstands repeated high-RPM cycling
• Fits intake and exhaust valve positions
• Machined for consistent seat contact
• Direct replacement for the stock retainer

Fits These Machines

• for Sea-Doo GTS 1503, 2015

On-The-Job Use

• Valve spring replacement during a top-end rebuild
• Valvetrain service on a 1503 engine
• Cylinder head repair after valve damage

Specs At A Glance

Good To Know

Q: Does this retainer fit both intake and exhaust valves? A: Yes, it fits both valve positions on the 1503 engine. Q: Should retainers be replaced in sets? A: Replacing all retainers together is good practice during a rebuild for even wear.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.