Intake Exhaust Valve Spring Retainer for Sea-Doo GTX IS 215 1503 2010-2011

Intake/Exhaust Valve Spring Retainer for Sea-Doo

This intake/exhaust valve spring retainer for Sea-Doo keeps valve springs properly seated in the 1503 engine found in the GTX IS 215, supporting consistent valvetrain operation.

Overview

This valve spring retainer for Sea-Doo is a valvetrain component that holds the valve spring in position on the valve stem. It is built for the GTX IS 215 1503 platform, giving riders a direct replacement for a worn or damaged retainer. Install it during top-end service so the valve spring stays aligned and the engine keeps breathing the way it should.

Built For Performance

• Holds the valve spring securely in place on the valve stem
• Designed for the 1503 engine platform
• Fits both intake and exhaust valve positions
• Constructed for the loads seen in marine valvetrain service
• Sold individually for targeted replacement

Fits These Machines

• for Sea-Doo GTX IS 215 1503 (2010-2011)

On-The-Job Use

• Top-end rebuilds and valve service on the 1503 engine
• Replacing a worn retainer during spring or seal work
• Routine maintenance on the GTX IS 215 platform
• Freshwater and saltwater personal watercraft use

Specs At A Glance

Good To Know

Q: Do I need to replace the valve springs at the same time? A: It depends on the condition of the springs themselves, so inspect them for wear or fatigue before reinstalling. If any doubt exists, replacing springs and retainers together is the safer path.

Q: Is this retainer sold as a set? A: This listing covers the valve spring retainer as a single component for the 1503 engine. Check your service manual for the quantity your specific valve job requires.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.