Intake Exhaust Valve Spring Retainer for Sea-Doo Speedster 260 1503 2012

Intake/Exhaust Valve Spring Retainer for Sea-Doo Speedster 1 x 260 1503

This intake and exhaust valve spring retainer is a direct-fit component for the Sea-Doo Speedster 1 x 260 1503 engine, keeping valve springs locked to the valve stem so the valvetrain stays reliable at high RPM.

Overview

This valve spring retainer is built for the Sea-Doo Speedster 1 x 260 1503, holding valve springs at the correct installed height on the 2012 model. It is an essential part for any top-end service on this engine, from a single spring replacement to a full valve job. Anyone maintaining or rebuilding a Speedster 1 x 260 will find this retainer a dependable fit.

Built For Performance

• Precision-machined to hold valve springs at the correct installed height
• Maintains valve spring tension for consistent valve timing
• Direct replacement for the factory retainer on the 1503 engine
• Works with both intake and exhaust valve positions
• Resists heat and fatigue in high-RPM marine applications

Fits These Machines

• for Sea-Doo Speedster 1 x 260 with 1503 engine, 2012

On-The-Job Use

• Valve spring replacement during a top-end rebuild
• Servicing worn or compressed valve springs on the 1503 engine
• Resealing valve guides and seals
• Routine inspection of the valvetrain in Speedster 1 x 260 boats

Specs At A Glance

Good To Know

Q: How many retainers do I need for a full valve job? A: The 1503 engine uses one retainer per valve, so count your valves to order the right quantity. Inspect all of them at once since they wear at a similar rate.

Q: Can I reuse my old retainers? A: Reusing worn retainers can cause valve spring pressure loss and poor engine performance. Replacing them during a valve service is good practice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.