Intake Exhaust Valve Spring Retainer for Sea-Doo Wake Pro 215 1503 2009-2016

Intake/Exhaust Valve Spring Retainer for Sea-Doo Wake Pro 215 1503

This intake/exhaust valve spring retainer holds the valve spring correctly seated on the valve stem in the 1503 engine used by the Wake Pro 215, keeping spring pressure stable through the valvetrain cycle.

Overview

This valve spring retainer is a direct-fit component for the 1503 engine found in the Sea-Doo Wake Pro 215. It secures the valve spring to the stem so the spring stays square and applies even pressure. As a replacement valvetrain part for both intake and exhaust positions, this spring retainer fits riders and builders servicing a 1503 top end.

Built For Performance

• Maintains correct valve spring installed height at high RPM
• Fits both intake and exhaust valve positions on the 1503 engine
• Machined for a consistent seat against the retainer groove
• Built to handle the sustained loads the Wake Pro 215 sees on the water
• Sold as a replacement component, not an original manufacturer part

Fits These Machines

• for Sea-Doo Wake Pro 215 1503
• for Sea-Doo models running the 1503 engine

On-The-Job Use

• Top-end rebuilds on the 1503 engine
• Valve spring replacement after valvetrain wear
• Refresh of a high-hour Wake Pro 215 engine
• Shop-level cylinder head service

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this valve spring retainer is an aftermarket replacement intended for the 1503 engine. Treat the brand reference as fitment guidance only.

Q: How many retainers should I order for a full head? A: Count the valves in your cylinder head and order one retainer per valve position. Confirm the exact count against your engine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.