Intake Exhaust Valve Spring Retainer for Sea-Doo Wake SE 430 1503 2010-2011

Intake/Exhaust Valve Spring Retainer for Sea-Doo

This intake/exhaust valve spring retainer is a direct replacement component that locks the valve spring in place on the 1503 engine, keeping valvetrain geometry stable at high RPM.

Overview

This intake/exhaust valve spring retainer for Sea-Doo is built to hold valve springs securely on the 1503 four-stroke engine used in the Wake and SE 430 models. The retainer keeps spring pressure consistent so valves open and close on schedule, protecting compression and power output. It suits riders and mechanics rebuilding a top end or replacing worn valvetrain hardware on 2010-2011 Wake and SE 430 watercraft.

Built For Performance

• Precision-machined to match the 1503 valve spring seat and keeper geometry
• Retains factory spring installed height for correct valve timing
• Hardened surface resists wear from continuous high-RPM operation
• Withstands heat cycling inside the cylinder head
• Direct-fit replacement for the original retainer position

Fits These Machines

• for Sea-Doo Wake 430
• for Sea-Doo Wake SE
• for Sea-Doo SE 430
• 2010-2011 1503 engine models

On-The-Job Use

• Top-end rebuilds on 1503 four-stroke engines
• Valve spring replacement during cylinder head service
• Refreshing valvetrain hardware on high-hour watercraft
• Keeping spring pressure consistent during long rides

Specs At A Glance

Good To Know

Q: Does this retainer fit both intake and exhaust valves? A: Yes, it is listed for both intake and exhaust valve positions on the 1503 engine. Confirm your model and year before ordering.

Q: Can I reuse my old keepers with this retainer? A: Reusing keepers is possible if they show no wear or damage, but new keepers are recommended during a rebuild. Always verify fit against your serial number.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.