Intake Manifold Runner Control Motor+COUPLER for Hyundai Tucson Kia Forte Rondo

Intake Manifold Runner Control Motor with Coupler for Hyundai and Kia

This intake manifold runner control motor with coupler actuates the variable intake runner flaps on the listed Hyundai and Kia engines, restoring proper airflow tuning through the intake tract.

Overview

This intake manifold runner control motor with coupler replaces a failed actuator so the intake runner flaps move on command again. The intake manifold runner control motor works with the included coupler to link the actuator to the runner shaft. It suits owners and technicians repairing driveability faults on the listed Hyundai and Kia models.

Built For Performance

• Electric actuator motor drives the intake runner flap linkage directly
• Included coupler connects the motor to the runner shaft
• Housing built to withstand engine bay heat and vibration
• Plug-in electrical connector matches the factory harness layout
• Direct replacement for the failed original actuator unit

Fits These Machines

• for Hyundai Tucson
• for Kia Forte
• for Kia Rondo

On-The-Job Use

• Restoring intake runner flap movement after an actuator failure
• Clearing driveability and intake tuning faults on the listed models
• Routine intake system repair during manifold service
• Replacing a seized or noisy runner control motor

Specs At A Glance

Good To Know

Q: Will this fix a rough idle caused by stuck runner flaps? A: It can when the fault traces to a failed runner control motor, since the new motor restores flap movement. Confirm the diagnosis first, as vacuum leaks and other faults can cause similar symptoms.

Q: Do I need to reuse the old coupler? A: No, a coupler is included with the motor, so the linkage can be fitted without sourcing the connector separately. Check the runner shaft for wear before installing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.