IT200 Rear Shock Seal Head Assembly for Yamaha IT 200 1984-1986

Rear Shock Seal Head Assembly for Yamaha IT200

This rear shock seal head assembly rebuilds the sealing section of the rear shock on Yamaha IT200 models from 1984 through 1986, restoring proper damping and preventing oil loss.

Overview

This rear shock seal head assembly is a rebuild component for the rear shock on the Yamaha IT200. It replaces the worn seal head at the top of the shock body, sealing in shock oil and keeping the damping rod aligned during travel. It is meant for riders and suspension techs servicing or rebuilding the rear shock on a 1984 to 1986 IT200.

Built For Performance

• Seal head assembly designed to fit the rear shock on Yamaha IT200 models
• Seals shock oil inside the body while allowing the damping rod to move smoothly
• Replaces a worn or leaking seal head to restore consistent damping
• Constructed to withstand the pressures and heat of rear shock operation
• Direct-fit rebuild part for 1984 through 1986 IT200 rear shocks

Fits These Machines

• for Yamaha IT200 (1984-1986)

On-The-Job Use

• Rear shock rebuilds and revalving on IT200 models
• Fixing oil leaks at the top of the shock body
• Restoring damping performance on older trail and enduro bikes
• Suspension service during a full bike refresh

Specs At A Glance

Good To Know

Q: Do I need special tools to install a rear shock seal head assembly? A: Rebuilding a rear shock typically requires a seal head tool, a nitrogen charge setup, and shock oil. Professional suspension service is recommended if you do not have this equipment.

Q: Will this seal head assembly fit other Yamaha models? A: This assembly is listed specifically for the 1984 to 1986 Yamaha IT200. Confirm your exact model and year before ordering to be certain of fitment.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.