Jackshaft & Chain Case Bearing & Seal Kit for Ski-Doo Legend 500 SS 2004

Jackshaft & Chain Case Bearing & Seal Kit for Ski-Doo Legend 500 SS

This jackshaft and chain case bearing and seal kit for Ski-Doo Legend 500 SS supplies the bearings and seals needed to refresh the drive system and keep the chain case sealed.

Overview

This jackshaft and chain case bearing and seal kit for Ski-Doo Legend 500 SS addresses the bearings and seals that wear with every mile of riding. The jackshaft and chain case bearing and seal kit helps restore smooth shaft rotation while new seals hold lubricant in and keep water and grit out. It suits owners and shops servicing the 2004 Legend 500 SS.

Built For Performance

• Bearings sized for the jackshaft and chain case positions on the Legend 500 SS
• Seals included to contain lubricant and block moisture and debris
• Direct replacement for worn or noisy factory bearings
• Helps smooth driveline operation and cut chain case noise
• Single kit covering multiple wear points

Fits These Machines

• for Ski-Doo Legend 500 SS, 2004

On-The-Job Use

• Chain case rebuilds and pre-season driveline service
• Replacing rough or noisy jackshaft bearings
• Sealing the chain case against oil seepage and water intrusion
• Preventive maintenance to extend driveline life

Specs At A Glance

Good To Know

Q: Does the chain case need to be opened to fit this kit? A: Yes, the cover usually comes off so the bearings and seals can be installed in their bores. Consult your service manual for torque specs and reassembly order.

Q: Is it worth replacing seals along with the bearings? A: Replacing both while the case is open saves a second teardown later, since seals and bearings tend to wear together. This kit provides them as a matched set.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.