Jet Pump Assembly for Sea-Doo GTI STD 130 1630 2020-2026

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a replacement propulsion unit for Sea-Doo GTI STD 130 1630 personal watercraft, driving water through the impeller to create thrust.

Overview

This jet pump assembly is made as a direct replacement for the Sea-Doo GTI STD 130 1630 watercraft. The jet pump assembly pushes water through the impeller housing to deliver thrust and steering response on the water. It suits owners who need to swap out a worn or damaged pump on their 2020-2026 model.

Built For Performance

• Built to match the 1630 engine platform's pump needs
• Housing and impeller shaped for steady water flow
• Sealed bearing and shaft assembly for smooth spin
• Wear ring surface to hold impeller clearance
• Corrosion-resistant materials for marine use

Fits These Machines

• for Sea-Doo GTI STD 130 1630 (2020-2026)

On-The-Job Use

• Replacing a pump after debris intake
• Restoring thrust on a high-hour GTI STD 130
• Servicing the jet drive during off-season upkeep
• Rebuilding a ski with a worn wear ring or impeller

Specs At A Glance

Good To Know

Q: Does this jet pump assembly require special tools to install? A: Basic hand tools and a torque wrench are usually enough, though a pump removal tool may help on some models. Follow your service manual's torque specs for the mounting bolts.

Q: Will this fit my 2022 GTI STD 130 without modification? A: It is listed for the 2020-2026 GTI STD 130 1630 platform and should bolt up directly. Always verify your hull's serial number and pump part number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.