Jet Pump Assembly for Sea-Doo GTI STD Rental 1503 2019

Jet Pump Assembly for Sea-Doo GTI STD Rental

This jet pump assembly is a complete propulsion unit for the Sea-Doo GTI STD Rental 1503, moving water from the intake to the nozzle to drive the craft forward.

Overview

This jet pump assembly is built for the Sea-Doo GTI STD Rental 1503, providing the impeller housing, wear ring, and stator section needed to restore thrust on the water. It handles the job of pulling water in and pushing it out under pressure, giving the craft its forward drive. Riders and mechanics working on the 2019 GTI STD Rental will find this jet pump assembly a direct replacement option for a worn or damaged unit.

Built For Performance

• Complete pump housing with impeller and wear ring installed
• Stator vanes straighten water flow for efficient thrust
• Sealed bearings reduce drag and vibration at speed
• Cast and machined components for durability in salt or fresh water
• Bolts to the hull intake and nozzle without modification

Fits These Machines

• for Sea-Doo GTI STD Rental 1503 (2019)

On-The-Job Use

• Replacing a damaged pump after ingesting debris
• Restoring top speed and acceleration on a tired craft
• Servicing the jet drive during seasonal maintenance
• Rebuilding a personal watercraft for resale

Specs At A Glance

Good To Know

Q: Will this jet pump assembly fit my 2019 GTI STD Rental? A: It is intended for the Sea-Doo GTI STD Rental 1503, but fit can depend on hull serial number and pump revision, so confirm compatibility before ordering.

Q: Does the assembly arrive ready to install? A: It ships as a complete pump unit, though you should inspect the impeller, wear ring, and seals and replace any worn parts before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.