Jet Pump Assembly for Sea-Doo GTR 230 1630 2020-2026

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a replacement propulsion unit for Sea-Doo GTR 230 1630 personal watercraft, moving water through the impeller to generate thrust.

Overview

This jet pump assembly is built as a direct replacement for the Sea-Doo GTR 230 1630 watercraft. The jet pump assembly channels water through the impeller housing to produce forward thrust and steering response on the water. It suits riders who need to replace a worn or damaged pump on their 2020-2026 model.

Built For Performance

• Designed to match the 1630 engine platform's pump requirements
• Housing and impeller engineered for consistent water flow
• Sealed bearing and shaft assembly for smooth rotation
• Wear ring surface to maintain impeller clearance
• Corrosion-resistant materials for marine environments

Fits These Machines

• for Sea-Doo GTR 230 1630 (2020-2026)

On-The-Job Use

• Replacing a damaged pump after debris intake
• Restoring thrust on a high-hour GTR 230
• Servicing the jet drive during off-season maintenance
• Rebuilding a ski with a worn wear ring or impeller

Specs At A Glance

Good To Know

Q: Does this jet pump assembly need any special tools to install? A: Basic hand tools plus a torque wrench are typical, though a pump removal tool may help on some models. Follow your service manual's torque specs for the mounting bolts.

Q: Will this fit my 2021 GTR 230 without modification? A: It is listed for the 2020-2026 GTR 230 1630 platform and should bolt up directly. Always verify your hull's serial number and pump part number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.