Jet Pump Assembly for Sea-Doo GTR X 230 1503 2018-2019

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit for Sea-Doo GTR X 230 1503 watercraft, moving water through the impeller to drive the ski forward.

Overview

This jet pump assembly is built for Sea-Doo GTR X 230 1503 models and serves as the primary propulsion component of the craft. The jet pump assembly channels water from the intake through the impeller to generate thrust. It suits riders replacing a worn or damaged pump on a 2018 or 2019 Sea-Doo GTR X 230 1503.

Built For Performance

• Complete pump housing for direct replacement on 1503 engine models
• Impeller and wear ring interface designed to maintain consistent thrust
• Sealed bearing and shaft assembly for smooth rotation under load
• Corrosion-resistant housing suited to repeated fresh and salt water use
• Mounting points matched to the GTR X hull for straightforward installation

Fits These Machines

• for Sea-Doo GTR X 230 1503 (2018)
• for Sea-Doo GTR X 230 1503 (2019)

On-The-Job Use

• Replacing a damaged pump after ingesting debris
• Restoring acceleration and top speed on a worn impeller
• Routine driveline service on a 2018 or 2019 GTR X 230
• Rebuilding a ski used for recreation and tow sports

Specs At A Glance

Good To Know

Q: Will this fit my 2018 or 2019 Sea-Doo GTR X 230 1503? A: It is intended for the 2018 to 2019 GTR X 230 1503 platform, but confirm your hull and serial number before ordering. Q: Is the impeller included? A: Review the listing photos and details to confirm exactly which pump components are included in the assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.