Jet Pump Assembly for Sea-Doo GTS 130 1503 2012-2014

Jet Pump Assembly for Sea-Doo GTS 130 1503

This jet pump assembly is a complete propulsion unit that pulls water in and pushes it out to drive your personal watercraft forward, built as a direct replacement for the GTS 130 1503 application covering 2012 through 2014.

Overview

This jet pump assembly for Sea-Doo is the complete propulsion unit that pulls water in and pushes it out to drive your craft forward. It serves riders who need to replace a worn or damaged pump on a Sea-Doo GTS 130 1503 built between 2012 and 2014. The assembly installs as a direct-fit replacement so you can restore thrust without piecing together separate parts.

Built For Performance

• Complete housing engineered to guide water cleanly into the impeller
• Stator vanes shaped to reduce turbulence and recover thrust
• Wear ring surface designed to hold consistent impeller clearance
• Sealed bearing and shaft assembly for smooth, low-vibration rotation
• Mounting points matched to the GTS 130 hull for straightforward fitment

Fits These Machines

• for Sea-Doo GTS 130 1503 (2012)
• for Sea-Doo GTS 130 1503 (2013)
• for Sea-Doo GTS 130 1503 (2014)

On-The-Job Use

• Replacing a worn or damaged pump on a GTS 130 1503
• Restoring takeoff acceleration and top-end thrust
• Routine driveline service on 2012 to 2014 Sea-Doo personal watercraft

Specs At A Glance

Good To Know

Q: Is this a complete drop-in pump? A: It is a full jet pump assembly meant to replace the factory unit on the listed application, so no separate component sourcing is required. Confirm your model and year before ordering.

Q: Can I install it myself? A: Replacing a jet pump on a personal watercraft is a moderate job that calls for basic tools and a service manual. If you are unsure about driveline alignment, have a technician handle the install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.