Jet Pump Assembly for Sea-Doo GTS DT 1503 2014

Jet Pump Assembly for Sea-Doo GTS DT 1503

This jet pump assembly is a complete propulsion unit that draws water in and forces it out to drive your personal watercraft forward, serving as a direct replacement for the GTS DT 1503 application.

Overview

This jet pump assembly for Sea-Doo is the complete propulsion unit that draws water in and forces it out to move your watercraft forward. It is built for riders who need to restore thrust on a Sea-Doo GTS DT 1503 after impeller wear, housing damage, or bearing failure. The assembly works as a direct-fit replacement so you can get back on the water without hunting down individual components.

Built For Performance

• Complete pump housing built to channel water cleanly into the impeller
• Stator vanes shaped to straighten flow and recover thrust efficiently
• Wear ring surface designed to keep impeller clearances consistent
• Sealed bearing and shaft assembly for smooth, low-vibration rotation
• Mounting points matched to the GTS DT 1503 hull for straightforward installation

Fits These Machines

• for Sea-Doo GTS DT 1503 (2014)

On-The-Job Use

• Replacing a worn or damaged pump on a GTS DT 1503
• Restoring takeoff acceleration and top-end thrust
• Routine driveline service on a 2014 Sea-Doo personal watercraft

Specs At A Glance

Good To Know

Q: Is this a complete drop-in pump? A: It is a full jet pump assembly intended to replace the factory unit on the listed application, so no individual component sourcing is needed. Confirm your model and year before ordering.

Q: Can I install it myself? A: Replacing a jet pump on a personal watercraft is a moderate job that calls for basic tools and a service manual. If you are unsure about driveline alignment, have a technician handle the install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.