Jet Pump Assembly for Sea-Doo GTX Fish Pro 170 1630 2020-2021

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit that drives water through the impeller to push your personal watercraft forward; it is a replacement pump for the listed GTX Fish Pro model.

Overview

This jet pump assembly for Sea-Doo is designed to restore thrust and handling on the water. As a complete jet pump assembly, it manages water intake, pressurization, and flow so your craft responds properly under throttle. It suits riders servicing a compatible GTX Fish Pro 170.

Built For Performance

• Complete assembly covering pump housing, impeller, and wear ring
• Cast and machined components for consistent alignment
• Sealed bearings for smooth, low-vibration operation
• Direct-fit mounting points matched to the original pump
• Corrosion-resistant finishes for repeated salt or fresh water use
• Balanced impeller for stable thrust across the RPM range

Fits These Machines

• for Sea-Doo GTX Fish Pro 170 1630 (2020-2021)

On-The-Job Use

• Replacing a pump damaged by debris or wear
• Restoring acceleration and top-end thrust
• Freshwater and saltwater riding conditions
• Routine driveline service on personal watercraft
• Repair or refurbishment of a sidelined craft

Specs At A Glance

Good To Know

Q: Does this jet pump assembly come as a complete unit? A: It is offered as an assembled jet pump so the housing, impeller, and wear components arrive together for a direct swap.

Q: Will it fit my GTX Fish Pro 170? A: It is listed for the GTX Fish Pro 170 1630 of the 2020-2021 model years, but serial number variations exist, so verify compatibility before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.