Jet Pump Assembly for Sea-Doo Speedster 255 1503 2012 2 Pack

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit for Sea-Doo Speedster watercraft, moving water through the impeller to drive the boat forward.

Overview

This jet pump assembly is built for Sea-Doo Speedster models and serves as the core propulsion component that converts engine power into thrust on the water. The jet pump assembly bolts into the hull and channels pressurized water rearward for forward motion and steering response. It is the right part for riders replacing a worn or damaged pump on a 1503-powered Speedster.

Built For Performance

• Complete pump housing assembly designed for direct installation
• Machined impeller and wear ring interface for consistent water flow
• Sealed bearing and shaft arrangement built to handle continuous marine use
• Corrosion-resistant castings suited to fresh and salt water environments
• Streamlined internal passages that support efficient thrust output

Fits These Machines

• for Sea-Doo Speedster 2 x 255 1503, 2012

On-The-Job Use

• Replacing a worn jet pump on a Speedster 1503 boat
• Restoring thrust and steering response after impeller damage
• Routine driveline service on 2012 Speedster models
• Rebuilding a pump that has ingested debris or run dry

Specs At A Glance

Good To Know

Q: Is this a direct replacement for my Speedster's factory pump? A: It is built to match the 1503 jet pump configuration used on 2012 Speedster models, so verify your hull and engine setup before ordering. Q: Can I install this myself? A: Many owners complete the swap with standard hand tools, though aligning the shaft and sealing the housing correctly matters.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.