Jet Pump Assembly for Sea-Doo Speedster 260 1503 2012 1 Pack

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit for Sea-Doo Speedster watercraft, driving water through the impeller to push the boat forward.

Overview

This jet pump assembly is made for Sea-Doo Speedster models and acts as the main propulsion component that turns engine output into thrust on the water. The jet pump assembly mounts into the hull and moves pressurized water rearward for acceleration and steering control. It suits riders replacing a worn or damaged pump on a 1503-equipped Speedster.

Built For Performance

• Full pump housing assembly ready for installation
• Machined impeller and wear ring pairing for steady water flow
• Sealed bearing and shaft layout built for continuous marine operation
• Corrosion-resistant castings suited to fresh and salt water use
• Smooth internal passages that support efficient thrust delivery

Fits These Machines

• for Sea-Doo Speedster 1 x 260 1503, 2012

On-The-Job Use

• Replacing a worn jet pump on a Speedster 1503 boat
• Restoring thrust and steering feel after impeller damage
• Routine driveline service on 2012 Speedster models
• Rebuilding a pump that has taken in debris or run dry

Specs At A Glance

Good To Know

Q: Will this fit my Speedster's factory pump location? A: It is built to match the 1503 jet pump setup used on 2012 Speedster models, so confirm your hull and engine configuration before ordering. Q: Is installation something I can do at home? A: Many owners handle the swap with standard hand tools, but shaft alignment and housing sealing need care.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.