Jet Pump Assembly for Sea-Doo Speedster 430 1503 2008

Jet Pump Assembly for Sea-Doo

This Jet Pump Assembly is a complete propulsion unit built to move water through your personal watercraft, and it serves as a direct replacement option for the factory pump on 2008 Sea-Doo Speedster 430 1503 models.

Overview

This Jet Pump Assembly is the rear propulsion unit that draws water in and forces it out to drive your craft forward. It is built for owners of the 2008 Sea-Doo Speedster 430 1503 who need to replace a worn, damaged, or seized pump. The assembly bolts in place of the original unit so you can get back on the water with a properly functioning jet drive.

Built For Performance

• Complete pump housing assembly ready to install
• Designed around the 1503 engine platform used in this model year
• Sealed bearing and impeller arrangement for consistent thrust
• Corrosion-resistant materials suited to fresh and salt water use
• Direct-fit mounting points that match the original pump location

Fits These Machines

• for Sea-Doo Speedster 430 1503 (2008)

On-The-Job Use

• Replacing a seized or damaged jet pump on a Speedster 430
• Restoring lost thrust after impeller or wear ring damage
• Routine driveline service on a 2008 1503-equipped boat
• Seasonal rebuilds before the boat goes back in the water

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket replacement Jet Pump Assembly made for Sea-Doo Speedster 430 1503 applications and is not an OEM part.

Q: Will this fit any year of the Speedster 430? A: Fitment is listed for the 2008 model with the 1503 engine, so confirm your year and engine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.