Jet Pump Assembly for Sea-Doo Wake 2 x 155 1503 2012

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a full propulsion unit that pulls water through the intake and forces it out the nozzle to drive your personal watercraft, and it serves as a replacement pump for 2012 Sea-Doo Wake 2 x 155 1503 models.

Overview

This jet pump assembly is built to restore thrust and steering response on a 2012 Sea-Doo Wake 2 x 155 1503. The jet pump assembly manages water flow from intake to nozzle, so it directly affects acceleration, top speed, and handling on the water. It suits owners replacing a worn, damaged, or seized pump on their Sea-Doo.

Built For Performance

• Complete assembly with housing, impeller, and wear ring
• Designed for the 1503 engine platform configuration
• Sealed bearings support high-RPM operation
• Stainless steel impeller resists corrosion in fresh and salt water
• Direct-fit mounting for the 2012 Wake 2 x 155 hull

Fits These Machines

• for Sea-Doo Wake 2 x 155 1503, 2012

On-The-Job Use

• Replacing a pump damaged by ingested debris
• Restoring top speed and hole-shot on a used craft
• Servicing a pump that has lost thrust or vibrates
• Seasonal maintenance on a 2012 Sea-Doo

Specs At A Glance

Good To Know

Q: Will this pump assembly fit any other Sea-Doo model year? A: This listing covers fitment for the 2012 Wake 2 x 155 with the 1503 engine. Check your hull and engine code before ordering, since pumps vary across years and trim levels.

Q: Does a jet pump assembly come with everything needed to install? A: The assembly is sold as a complete pump unit; mounting hardware and sealant are typically not included unless shown in the listing photos. Reuse or replace fasteners and seals as needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.