Jet Pump Assembly for Sea-Doo Wake P STD 155 1503 2018

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit that draws water in and forces it out to drive your personal watercraft forward, and it serves as a direct replacement for the factory pump on 2018 Sea-Doo Wake P STD 155 1503 models.

Overview

This jet pump assembly is built to restore thrust and acceleration to a 2018 Sea-Doo Wake P STD 155 1503. The jet pump assembly handles water intake, pressurization, and steering on the water, making it a core component of the craft. It suits riders replacing a worn, damaged, or seized pump on their Sea-Doo.

Built For Performance

• Complete assembly combining housing, impeller, and wear ring
• Designed for the 1503 engine platform configuration
• Sealed bearings support high-RPM operation
• Stainless steel impeller resists corrosion in fresh and salt water
• Direct-fit mounting for the 2018 Wake P STD 155 hull

Fits These Machines

• for Sea-Doo Wake P STD 155 1503, 2018

On-The-Job Use

• Replacing a damaged pump after ingesting debris
• Restoring top speed and hole-shot on a used craft
• Servicing a pump that has lost thrust or vibrates
• Seasonal maintenance on a 2018 Sea-Doo

Specs At A Glance

Good To Know

Q: Will this pump assembly fit any other Sea-Doo model year? A: This listing covers fitment for the 2018 Wake P STD 155 with the 1503 engine. Check your hull and engine code before ordering, since pumps vary across years and trim levels.

Q: Does a jet pump assembly come with everything needed to install? A: The assembly is sold as a complete pump unit; mounting hardware and sealant are typically not included unless shown in the listing photos. Reuse or replace fasteners and seals as needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.