Jet Pump Assembly for Sea-Doo Wake Pro HO 1503 2019

Jet Pump Assembly for Sea-Doo

This jet pump assembly is a complete propulsion unit for Sea-Doo watercraft, channeling water through the impeller to produce forward thrust. It suits riders replacing a worn or damaged pump on their personal watercraft.

Overview

The jet pump assembly is the key propulsion component on a Sea-Doo, pulling water in and pushing it out the nozzle to drive the craft. This jet pump assembly is built for owners who need to bring thrust back after wear or impact damage. It installs as a direct-fit replacement so you skip tracking down each internal part separately.

Built For Performance

• Complete pump housing with integrated impeller and wear ring
• Stainless steel impeller for corrosion resistance in fresh and salt water
• Sealed bearing and shaft assembly to handle continuous high-RPM operation
• Cast housing engineered to match the original mounting points
• Venturi and steering nozzle included for consistent handling

Fits These Machines

• for Sea-Doo Wake Pro HO 1503, 2019

On-The-Job Use

• Replacing a pump damaged by rocks, sand, or debris intake
• Restoring thrust on a craft with a worn wear ring or impeller
• Routine driveline service on high-hour Sea-Doo watercraft
• Tow and wake duty where consistent pump output matters

Specs At A Glance

Good To Know

Q: Is this pump a direct replacement for my Sea-Doo? A: It is designed as a bolt-on jet pump assembly for the listed Wake Pro HO 1503 model year, but confirming your serial number and pump part number is recommended before ordering.

Q: Do I need to replace the wear ring separately? A: This assembly includes the pump internals, but always check your existing driveline and seals so you install a complete, correctly matched unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.