Jet Pump Fitting & Outlet Set for Sea-Doo Sportster 720 96-00

Jet Pump Fitting & Outlet Set for Sea-Doo Sportster 720

This jet pump fitting and outlet set is a replacement assembly for the 720-powered Sea-Doo Sportster, routing cooling water and pump pressure where the engine and exhaust system need it.

Overview

This jet pump fitting and outlet set is made for the Sea-Doo Sportster 720 and covers the pump connections that feed and return water through the hull. It replaces worn or corroded fittings so the jet pump circuit stays sealed and the cooling flow stays steady. A solid choice for riders refreshing the pump plumbing on a 1996 to 2000 Sportster.

Built For Performance

• Direct replacement for the original pump fitting and outlet positions
• Seals the pump circuit against leaks under pressure
• Maintains steady cooling water flow to the engine
• Corrosion-resistant construction suited to marine use
• Simple bolt-on install with standard hand tools

Fits These Machines

• for Sea-Doo Sportster 720 (1996-2000)

On-The-Job Use

• Routine jet pump service and rebuilds
• Replacing cracked or corroded pump fittings
• Cooling system repairs after overheating
• Winterizing and pre-season pump checks

Specs At A Glance

Good To Know

Q: Will this fit my Sportster with the 720 engine? A: It is listed for Sportster 720 models from 1996 through 2000, and fit can vary by serial number. Check your hull and pump configuration before ordering.

Q: Do I need to replace gaskets or seals at the same time? A: Inspect the gaskets and seals around the pump fittings when you install this set. Replacing worn seals at the same time helps prevent leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.