Jet Pump Housing for Yamaha FX HO 1100 2004-2008

Jet Pump Housing for Yamaha FX HO 1100

This jet pump housing is a replacement component that secures the impeller and wear ring assembly on Yamaha FX HO 1100 personal watercraft, keeping water flow through the pump consistent for 2004 through 2008 models.

Overview

This jet pump housing forms the outer casing of the pump on the Yamaha FX HO 1100, holding the impeller and wear ring in proper alignment. The housing guides water drawn in by the impeller and pushes it through the nozzle to create forward thrust. It fits owners replacing a cracked, corroded, or worn housing on 2004 to 2008 FX HO 1100 watercraft.

Built For Performance

• Cast and machined to match the stock pump housing profile for the FX HO 1100
• Preserves correct impeller-to-housing clearance for efficient thrust
• Corrosion-resistant build suited to regular marine exposure
• Direct-fit replacement for the factory housing on supported model years
• Solid mounting surfaces for the wear ring and pump internals

Fits These Machines

• for Yamaha FX HO 1100, 2004-2008

On-The-Job Use

• Replacing a damaged or corroded housing during pump service
• Rebuilding the jet pump after wear ring or impeller work
• Restoring steady water flow and thrust on older FX HO 1100 watercraft
• Routine pump maintenance on 2004 to 2008 models

Specs At A Glance

Good To Know

Q: Is the impeller included with this jet pump housing? A: No, this listing covers the housing only, so the impeller and wear ring are sourced separately. Inspect and replace those internals as needed while the pump is apart.

Q: Will this housing fit my FX HO 1100? A: It is listed for 2004 through 2008 FX HO 1100 models, though pump setups can differ across years. Check your model year and serial number against the existing housing before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.