Jet Pump Housing for Yamaha SX 210 1100 2006-2015 Boat

Jet Pump Housing for Yamaha SX 210 1100

This jet pump housing is a replacement housing unit for Yamaha SX 210 1100 personal watercraft, built to contain the impeller and pump assembly and direct water flow for jet propulsion.

Overview

This jet pump housing is made to fit the Yamaha SX 210 1100 and provides the outer structure for the jet pump assembly. It holds the impeller and related components in alignment so water moves through the drive with consistent pressure. It suits riders replacing a worn or damaged housing on a 2006 to 2015 craft.

Built For Performance

• Holds the impeller and wear ring for correct pump alignment
• Direct replacement fit for the Yamaha SX 210 1100 pump section
• Corrosion-resistant cast body for fresh and salt water use
• Keeps the factory water flow path for steady jet thrust
• Machined mounting points for straightforward bolt-on installation

Fits These Machines

• for Yamaha SX 210 1100, 2006
• for Yamaha SX 210 1100, 2007
• for Yamaha SX 210 1100, 2008
• for Yamaha SX 210 1100, 2009
• for Yamaha SX 210 1100, 2010-2015

On-The-Job Use

• Replacing a cracked housing after impact or debris damage
• Rebuilding the jet pump during routine seasonal service
• Restoring correct water flow on a 2006 to 2015 SX 210 1100
• Repairing corrosion from repeated salt water operation

Specs At A Glance

Good To Know

Q: Does this housing fit all 2006 to 2015 Yamaha SX 210 1100 models? A: This housing is listed for the Yamaha SX 210 1100 across the 2006 to 2015 range. Verify your serial number and pump setup before ordering.

Q: Should I replace the wear ring and seals at the same time? A: It is common to renew the wear ring, seals, and gaskets when installing a jet pump housing. Reusing old sealing parts can lead to water intrusion or reduced thrust.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.