Jet Pump Housing for Yamaha SX 230 HO 1100 2005-2009

Jet Pump Housing for Yamaha

This jet pump housing is the stationary housing that carries the impeller and wear ring on Yamaha 1100 series jet drives, delivering the structural support and wear surface needed on the 2005-2009 SX 230 HO.

Overview

This jet pump housing for Yamaha fits the 1100 engine platform used across the 2005-2009 SX 230 HO run. As a direct replacement, this jet pump housing restores the correct impeller clearance that keeps acceleration crisp and cavitation under control. An ideal part for owners handling their own pump rebuild or replacement.

Built For Performance

• Machined to hold the impeller and wear ring in proper alignment
• Sturdy housing body resists flex under high thrust loads
• Precision bore maintains impeller clearance for reduced cavitation
• Corrosion-resistant finish suited to fresh and salt water use
• Direct replacement fit for the 1100 series pump assembly

Fits These Machines

• for Yamaha SX 230 HO 1100 (2005-2009)
• for Yamaha 1100 series jet pump applications

On-The-Job Use

• Rebuilding a worn pump after impeller or wear ring damage
• Restoring lost top-end speed and holeshot on the water
• Routine pump service and seasonal maintenance
• Repairing a housing damaged by ingested debris

Specs At A Glance

Good To Know

Q: Will this housing fit my 2007 SX 230 HO? A: It is intended for the 1100 series SX 230 HO built between 2005 and 2009, but confirm your serial number and pump assembly before ordering.

Q: Do I need new wear ring or impeller hardware with it? A: It is good practice to inspect the wear ring, impeller, and seals while the pump is apart so you can replace anything worn at the same time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.