Jet Pump Wear Ring 144mm ID for Yamaha SuperJet 700 1995-2020

Jet Pump Wear Ring for Yamaha

The Jet Pump Wear Ring for Yamaha is a 144mm ID replacement ring that restores the close clearance between the impeller and pump housing for consistent thrust and reduced cavitation.

Overview

This Jet Pump Wear Ring for Yamaha is a direct replacement for a worn or scored pump housing ring, sized at 144mm ID to match the impeller diameter. It keeps the impeller tip clearance tight so the pump moves water efficiently instead of losing pressure. Ideal for riders rebuilding a pump or chasing a loss of top speed on a SuperJet 700.

Built For Performance

• 144mm inner diameter sized to match the stock impeller diameter
• Restores tight impeller tip clearance for stronger thrust
• Reduces cavitation and pump slip under acceleration
• Precision machined for a consistent, round sealing surface
• Replacement for a worn, scored, or swollen factory ring
• Direct fit into the pump housing without modifications

Fits These Machines

• for Yamaha SuperJet 700, 1995-2020

On-The-Job Use

• Rebuilding a jet pump during a seasonal service
• Restoring lost top speed and holeshot on a SuperJet 700
• Replacing a ring scored by sand, gravel, or debris
• Refreshing a pump that has lost pressure after many hours

Specs At A Glance

Good To Know

Q: When should I replace the wear ring? A: Replace it when clearance between the impeller and ring grows enough to cause cavitation or a drop in top speed. Inspect the ring any time the pump is apart.

Q: Does it include the pump housing? A: No, this is the wear ring only. Reuse the pump housing and impeller unless they are also damaged.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.