Jet Pump Wear Ring 144mm ID for Yamaha Wave Raider 760 1996

Jet Pump Wear Ring for Yamaha Wave Raider 760

This jet pump wear ring for Yamaha Wave Raider 760 delivers a precise 144mm inner diameter fit to restore proper clearance between the impeller and pump housing.

Overview

The jet pump wear ring for Yamaha Wave Raider 760 is a replacement component that maintains the tight clearance between impeller and housing for consistent thrust. Riders and mechanics install this wear ring for Yamaha personal watercraft to reduce cavitation and recover lost acceleration. This jet pump wear ring suits the 1996 Wave Raider 760 and similar 144mm pump applications.

Built For Performance

• 144mm inner diameter matches the stock pump bore requirement
• Restores impeller-to-housing clearance to reduce cavitation
• Machined for a consistent circular profile around the impeller
• Durable construction resists abrasion from pumped water and debris
• Direct replacement for the worn ring in the pump assembly

Fits These Machines

• for Yamaha Wave Raider 760 (1996)

On-The-Job Use

• Rebuilding a jet pump during routine maintenance
• Correcting cavitation and slipping that shows up under acceleration
• Servicing the pump after ingesting sand or gravel
• Refreshing a freshwater or saltwater personal watercraft pump

Specs At A Glance

Good To Know

Q: How do I know the wear ring needs replacing? A: Cavitation, a slipping feel under acceleration, or visible scoring and clearance gaps on the old ring point to replacement. Measuring the inner diameter against 144mm confirms whether the ring is out of spec.

Q: Does the impeller need to come out to install it? A: Yes, the pump typically needs to be removed and the impeller taken off so the new ring can seat properly. Follow the service manual torque and clearance values when reassembling.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.