Jet Pump Wear Ring 155.3mm for Sea-Doo RX 951 2000-2002

Jet Pump Wear Ring for Sea-Doo RX 951

This jet pump wear ring is a replacement component for the 951 engine family, sized at 155.3mm ID, designed to hold the impeller-to-housing clearance so the pump delivers steady thrust.

Overview

This jet pump wear ring is a direct-fit replacement for the Sea-Doo RX 951 pump assembly, sized at 155.3mm ID to match the stock bore. It keeps the impeller clearance tight so water accelerates cleanly through the housing. Install this jet pump wear ring when the original shows scoring, cracks, or material loss that hurts pump performance.

Built For Performance

• 155.3mm inner diameter matched to the pump housing bore
• Machined bore for a consistent, close impeller clearance
• Built to resist wear from sand and debris in the water
• Restores pump pressure lost to a worn or scored ring
• Direct replacement for the 951 pump application

Fits These Machines

• for Sea-Doo RX 951
• for Sea-Doo RX

On-The-Job Use

• Wear ring replacement during jet pump service
• Bringing back acceleration and top speed
• Pump rebuilds and impeller replacements
• Reducing cavitation during hard acceleration

Specs At A Glance

Good To Know

Q: How do I know the wear ring needs replacing? A: A worn ring shows scoring, grooves, or material loss, and the pump loses thrust as clearance opens up. Inspect the ring whenever you service the pump.

Q: Will this fit my RX 951 pump? A: It is sized at 155.3mm ID for the 951 jet pump application. Verify the pump and serial number on your machine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.