Knock Detonation Sensor for Ski-Doo Expedition LE SE 600 E-Tec
Knock Detonation Sensor for Ski-Doo Expedition LE SE 600 E-Tec
Couldn't load pickup availability
Knock/Detonation Sensor for Ski-Doo Expedition LE & SE 600 E-Tec
This knock sensor is a replacement engine management component for the Ski-Doo Expedition LE and SE 600 E-Tec, detecting abnormal combustion and sending a signal so the engine control unit can adjust timing.
Overview
This knock sensor is a replacement component for the Ski-Doo Expedition LE and SE 600 E-Tec. It listens for the vibration signature of detonation and reports it to the engine control unit, which then trims ignition timing to protect the engine. Riders and mechanics servicing a 2011 to 2018 Expedition 600 E-Tec will find this knock sensor a practical replacement part.
Built For Performance
- Piezo sensing element tuned to the detonation frequency band of the 600 E-Tec engine
- Threaded mount that seats against the cylinder for reliable signal transfer
- Sealed connector body to resist moisture and engine bay heat
- Direct replacement footprint matching the original sensor location
- Built to withstand continuous vibration in a two-stroke engine bay
Fits These Machines
- for Ski-Doo Expedition LE 600 E-Tec, 2011-2018
- for Ski-Doo Expedition SE 600 E-Tec, 2011-2018
On-The-Job Use
- Servicing a sled that runs poorly or sets a knock-related fault code
- Engine rebuilds where the original sensor was damaged or reused
- Trail and utility riding where consistent engine timing matters
- Routine replacement during top-end or electrical service work
Specs At A Glance
| Type | Knock/Detonation Sensor |
| Machine | for Ski-Doo Expedition LE & SE 600 E-Tec |
| Model Years | 2011-2018 |
| Engine | 600 E-Tec |
Good To Know
Q: What does a knock sensor do on a 600 E-Tec? A: It detects the vibration of detonation and signals the engine control unit, which adjusts ignition timing to prevent engine damage. A failed sensor can cause poor running or a fault code.
Q: Is this an original Ski-Doo part? A: No, this is a replacement knock sensor for the Ski-Doo Expedition LE and SE 600 E-Tec. It is designed to fit the listed application.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
