Knock Detonation Sensor for Ski-Doo Legend 800 SDI 2003-2004
Knock Detonation Sensor for Ski-Doo Legend 800 SDI 2003-2004
Couldn't load pickup availability
Knock/Detonation Sensor for Ski-Doo Legend 800 SDI
This knock sensor is a replacement engine management component for the Ski-Doo Legend 800 SDI, designed to detect detonation and signal the ECU to adjust ignition timing for safe combustion.
Overview
This knock/detonation sensor for Ski-Doo Legend 800 SDI monitors combustion chamber vibration and sends a signal the engine control unit uses to pull timing when detonation is detected. It helps protect pistons and cylinder heads from damaging pre-ignition on 2003-2004 SDI models. Riders replacing a failed sensor will find it a direct-fit engine management part.
Built For Performance
- Piezo-electronic sensing element tuned to detect detonation frequencies
- Sealed connector to resist moisture and engine bay heat
- Mounts directly to the factory cylinder location
- Restores factory knock detection and timing control
- New replacement part, not a used sensor
Fits These Machines
- for Ski-Doo Legend 800 SDI 2003
- for Ski-Doo Legend 800 SDI 2004
On-The-Job Use
- Replacing a failed or intermittent knock sensor
- Restoring factory ignition timing protection
- Diagnosing check engine or detonation codes on 800 SDI engines
- Top-end service and engine rebuilds
Specs At A Glance
| Part Type | Knock/Detonation Sensor |
| Condition | New |
| Engine | 800 SDI |
| Years | 2003-2004 |
Good To Know
Q: Will this sensor fix a check engine light on my 800 SDI? A: If the fault code points to a knock or detonation sensor circuit, this replacement is intended to resolve it. Confirm the code with a scan tool before ordering.
Q: Does this sensor need to be torqued to a specific spec? A: Knock sensors are sensitive to mounting torque, so follow the factory specification for your model. Improper torque can cause false or missed detonation signals.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
