Knock Detonation Sensor for Ski-Doo MXZ TNT 600 E-Tec 2011-2018
Knock Detonation Sensor for Ski-Doo MXZ TNT 600 E-Tec 2011-2018
Couldn't load pickup availability
Knock/Detonation Sensor for Ski-Doo MXZ TNT 600 E-Tec
This knock/detonation sensor is a direct-fit replacement engine management component for Ski-Doo MXZ TNT 600 E-Tec snowmobiles, detecting abnormal combustion so the ECU can adjust timing and protect the engine.
Overview
This knock/detonation sensor monitors combustion noise inside the engine and sends a signal to the ECU when detonation is detected. It is built for Ski-Doo MXZ TNT 600 E-Tec riders who need a reliable replacement sensor to keep ignition timing in check. Fits 2011-2018 Ski-Doo MXZ TNT 600 E-Tec models.
Built For Performance
- Detects abnormal combustion vibration and signals the ECU to retard timing
- Direct-fit replacement for the original sensor location on 600 E-Tec engines
- Durable housing built to withstand engine bay heat and vibration
- Electrical connector matches factory harness for plug-in installation
- Helps protect pistons and cylinder heads from detonation-related damage
- Compatible with Ski-Doo MXZ TNT 600 E-Tec 2011-2018 models
Fits These Machines
- for Ski-Doo MXZ TNT 600 E-Tec 2011
- for Ski-Doo MXZ TNT 600 E-Tec 2012
- for Ski-Doo MXZ TNT 600 E-Tec 2013
- for Ski-Doo MXZ TNT 600 E-Tec 2014
- for Ski-Doo MXZ TNT 600 E-Tec 2015
- for Ski-Doo MXZ TNT 600 E-Tec 2016
- for Ski-Doo MXZ TNT 600 E-Tec 2017
- for Ski-Doo MXZ TNT 600 E-Tec 2018
On-The-Job Use
- Trail riding where fuel quality or altitude can trigger detonation
- Replacing a failed sensor causing poor running or check engine codes
- Routine engine maintenance on 600 E-Tec snowmobile engines
- Restoring proper ignition timing control after sensor failure
Specs At A Glance
| Part Type | Knock/Detonation Sensor |
| Vehicle Fitment | Ski-Doo MXZ TNT 600 E-Tec |
| Model Years | 2011-2018 |
Good To Know
Q: How do I know if my knock sensor has failed? A: Common signs include a check engine light, reduced power, poor fuel economy, or a stored detonation-related trouble code. A diagnostic scan can confirm whether the sensor is reading out of range.
Q: Does this sensor require any special tools to install? A: Installation is typically straightforward with basic hand tools, since the sensor mounts to the engine block and connects to the factory harness. Always disconnect the battery before starting the job.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
