Skip to product information
1 of 1

Knock Detonation Sensor for Ski-Doo MXZ TNT 800 P-Tek 2011

Knock Detonation Sensor for Ski-Doo MXZ TNT 800 P-Tek 2011

Regular price $136.39
Regular price Sale price $136.39
Sale Sold out
Quantity

Knock/Detonation Sensor for Ski-Doo MXZ TNT 800 P-Tek

This knock/detonation sensor detects abnormal combustion in the engine of your Ski-Doo MXZ TNT 800 P-Tek snowmobile and signals the ECU to adjust timing before damage occurs.

Overview

This knock/detonation sensor is a direct-fit replacement for the factory unit on the Ski-Doo MXZ TNT 800 P-Tek. The knock/detonation sensor monitors engine vibration frequencies that indicate pre-ignition or detonation, allowing the ECU to retard timing and protect the pistons. It suits riders maintaining or restoring a 2011 MXZ TNT 800 P-Tek.

Built For Performance

  • Detects detonation frequencies across the engine RPM range
  • Sends a signal the ECU reads to adjust ignition timing in real time
  • Threaded mount matches the factory sensor location on the 800 P-Tek engine
  • Sealed connector resists moisture and vibration common in snowmobile use
  • Direct replacement for the original sensor, no modification required

Fits These Machines

  • for Ski-Doo MXZ TNT 800 P-Tek 2011

On-The-Job Use

  • Replacing a failed or intermittent sensor that triggers a check engine light
  • Restoring proper ignition timing after drivability issues appear
  • Scheduled maintenance on a high-mileage MXZ TNT 800 P-Tek
  • Engine rebuild or top-end service where the sensor is removed and replaced

Specs At A Glance

Part Number(s) Knock/Detonation Sensor
Compatible Models Ski-Doo MXZ TNT 800 P-Tek 2011
Sensor Type Knock/Detonation

Good To Know

Q: How do I know if my knock sensor has failed? A: A failed knock sensor typically triggers a check engine light and may cause reduced power or poor fuel economy as the ECU defaults to a safe timing map. Testing resistance and signal output with a scan tool confirms the fault.

Q: Does this sensor need to be torqued to a specific spec? A: Yes, knock sensors are torque sensitive and must be tightened to the factory specification for the 800 P-Tek engine. Overtightening or undertightening can affect the sensor's ability to read detonation frequencies accurately.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details