Skip to product information
1 of 1

Knock Detonation Sensor for Ski-Doo MXZ XRS 600 E-Tec 2010-2018

Knock Detonation Sensor for Ski-Doo MXZ XRS 600 E-Tec 2010-2018

Regular price $136.39
Regular price Sale price $136.39
Sale Sold out
Quantity

Knock/Detonation Sensor for Ski-Doo MXZ XRS 600 E-Tec

This knock/detonation sensor detects abnormal combustion in the 600 E-Tec engine and signals the ECM to adjust timing, protecting pistons and cylinders from detonation damage on 2010-2018 MXZ XRS models.

Overview

The knock/detonation sensor for Ski-Doo MXZ XRS 600 E-Tec is a direct-fit replacement that monitors engine vibration and reports pre-ignition events to the ECM. This detonation sensor helps maintain safe combustion timing on the 600 E-Tec engine across the 2010-2018 model run. It is built for riders and mechanics servicing MXZ XRS snowmobiles who need a reliable sensor to restore factory engine protection.

Built For Performance

  • Piezo-electric sensing element tuned to factory detonation frequencies
  • Direct-fit connector and thread matching the 600 E-Tec engine block
  • Sealed housing resists moisture, snow, and vibration exposure
  • Withstands extreme temperature swings of cold-start and trail riding
  • Restores ECM knock detection for accurate ignition timing control

Fits These Machines

  • for Ski-Doo MXZ XRS 600 E-Tec, 2010-2018

On-The-Job Use

  • Trail riding where fuel quality and elevation shift combustion behavior
  • Mountain and deep snow use where engine load stays high
  • Routine maintenance when a knock sensor fault code appears
  • Rebuilds and top-end service on 600 E-Tec engines

Specs At A Glance

Part Type Knock/Detonation Sensor
Engine 600 E-Tec
Model Fitment MXZ XRS, 2010-2018

Good To Know

Q: How do I know if my knock sensor has failed? A: A failed sensor commonly sets a fault code, causes reduced power, or leads to timing that feels off under load. Diagnosing with a scan tool confirms whether the sensor is the cause.

Q: Does this sensor require programming after installation? A: No, a knock/detonation sensor is a plug-and-play component that the ECM reads directly. Simply install it, clear any stored codes, and verify operation on a test ride.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details