Skip to product information
1 of 1

Knock Detonation Sensor for Ski-Doo Summit SP 600 & 800 E-Tec 2012-2018

Knock Detonation Sensor for Ski-Doo Summit SP 600 & 800 E-Tec 2012-2018

Regular price $136.39
Regular price Sale price $136.39
Sale Sold out
Quantity

Knock/Detonation Sensor for Ski-Doo

This knock/detonation sensor detects abnormal combustion in the engine and signals the control module so timing can be adjusted before damage occurs, designed for Ski-Doo snowmobiles.

Overview

This knock/detonation sensor is a drop-in replacement for the factory engine management component on Ski-Doo Summit SP 600 and 800 E-Tec snowmobiles from 2012 to 2018. By listening for abnormal combustion, the detonation sensor helps the ECU pull timing when knock is detected, protecting pistons and cylinders during hard pulls. It is aimed at riders doing their own maintenance and shops servicing E-Tec sleds.

Built For Performance

  • Detects abnormal combustion and sends a signal directly to the engine control module
  • Allows the ECU to adjust ignition timing to protect the engine under load
  • Direct-fit replacement for the original sensor location on E-Tec engines
  • Designed to handle the heat and vibration of a two-stroke snowmobile engine bay
  • Simple bolt-on part that requires no tuning or calibration

Fits These Machines

  • for Ski-Doo Summit SP 600 E-Tec, 2012-2018
  • for Ski-Doo Summit SP 800 E-Tec, 2012-2018

On-The-Job Use

  • Replacing a failed or damaged sensor during engine diagnostics
  • Restoring proper knock protection after a top-end rebuild
  • Servicing high-mileage E-Tec sleds that throw detonation-related codes
  • Preventive replacement on engines run hard in deep snow and mountain terrain

Specs At A Glance

Part Type Knock/Detonation Sensor
Engine Family 600 & 800 E-Tec
Model Years 2012-2018
Vehicle Fit Ski-Doo Summit SP

Good To Know

Q: Will this sensor fit both the 600 and 800 E-Tec engines? A: It is listed for the 600 and 800 E-Tec used in the Summit SP from 2012 to 2018, but always check your engine code and serial number before ordering.

Q: Do I need to reprogram anything after installing the sensor? A: No, a knock sensor is a reporting component and does not require reprogramming, though clearing stored codes after replacement is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details