Knock Detonation Sensor for Ski-Doo Summit X 800 P-Tek 2009-2010
Knock Detonation Sensor for Ski-Doo Summit X 800 P-Tek 2009-2010
Couldn't load pickup availability
Knock/Detonation Sensor for Ski-Doo Summit X 800 P-Tek
This knock/detonation sensor is an engine management component that monitors vibration in the cylinder to detect abnormal combustion and signals the ECU to adjust timing, developed for Ski-Doo Summit X 800 P-Tek snowmobiles from 2009 to 2010.
Overview
This detonation sensor for Ski-Doo Summit X 800 P-Tek models detects the signature vibrations of pre-ignition and engine knock so the control unit can pull timing before damage occurs. It is a direct-fit replacement for riders maintaining their 2009 to 2010 Summit X 800 P-Tek. The knock sensor for Ski-Doo Summit X 800 P-Tek is built for dependable signal output in cold, high-load two-stroke conditions.
Built For Performance
- Piezo-electric sensing element tuned to the frequency range of two-stroke detonation
- Sealed housing resists snowmelt, moisture, and engine bay vibration
- Single-bolt mounting matches the factory location on the 800 P-Tek engine
- Connector and pin layout configured for plug-in replacement
- Withstands the heat cycling of a high-revving 800cc two-stroke powerplant
Fits These Machines
- for Ski-Doo Summit X 800 P-Tek, 2009
- for Ski-Doo Summit X 800 P-Tek, 2010
On-The-Job Use
- Serving as a diagnostic and protection component on the 800 P-Tek engine
- Detecting knock during deep snow climbing where load stays high
- Helping preserve pistons and cylinder heads under sustained wide-open throttle
- Restoring factory timing control after a failed or damaged sensor
Specs At A Glance
| Part Type | Knock/Detonation Sensor |
| Position | Engine cylinder block |
| Compatibility | Ski-Doo Summit X 800 P-Tek, 2009-2010 |
Good To Know
Q: How do I know the knock sensor has failed? A: Common signs include a check engine light, reduced power, and stored knock sensor fault codes. A scan tool reading of the engine management system confirms the diagnosis.
Q: Is this a direct replacement for the factory sensor? A: This sensor is designed to fit the specified 800 P-Tek models using the factory mounting point and connector. Confirm your model year and engine code before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
